Note:

This site's design is only fully visible in a graphical browser that supports web standards, however, its content is accessible to any browser or internet device. (It just won't look very good.)

Specifically, this site makes extensive use of Cascading Style Sheets (CSS) to control content layout.

Because you are seeing this message, your browser is not set up to display content using CSS.

Please enable style sheets, or use a browser that supports style sheets.

Directions to Aberdeen Proving Ground

Aberdeen Proving Ground is split between two areas; APG North located in Aberdeen, and APG South located in Edgewood. CECOM Headquarters is located at APG North as part of the Army C4ISR Center of Excellence. Please note: You will need a driver's license, vehicle registration, proof of car insurance, and the building information for the visit.

To APG North

  • From the south, take I-95 North towards New York.
    From destinations north of APG, take I-95 South towards Baltimore.
  • [Be advised of tolls]
  • Take exit 80 (Riverside/Churchville) and turn onto MD-543 South
  • Continue on MD 543 for approximately 1.5 miles
  • Take exit to US 40 East
  • Follow Route 40 and take the MD 715 exit for Aberdeen Proving Ground
  • Proceed to APG Visitor's Center on the right. Use far right-hand lane to access Visitor's Gate

To C4ISR Center of Excellence

  • Proceed through 715 gate, and make right onto Combat Drive
  • Then make first left onto Boothby Hill Road
  • Take first right onto Darlington Avenue
  • Arrive at C4ISR Center of Excellence

To APG South

  • From the south, take I-95 North towards New York.
    From destinations north of APG, take I-95 South towards Baltimore.
  • [Be advised of tolls]
  • Take exit 77 (Edgewood/Bel Air), Route 24 South toward Edgewood
  • Keep straight and follow signs to the Visitors' Center once you arrive at the installation

From APG North to APG South

  • Leave from the 715 gate, merge onto Route 40 West/Pulaski Hwy
  • Continue on Route 40 West/Pulaski Hwy for approximately 10 miles
  • Take Route 24 exit on right, just before the overpass
  • Make left at traffic signal light, onto route 24 and continue until reaching the Route 24 gate
  • Proceed through gate and Visitors' Center

From APG South to APG North

  • Exit APG through the Route 24 Gate
  • Take the Route 40/Pulaski Hwy exit on right and turn left onto Route 40 East at the traffic signal
  • Follow Route 40 and take the MD 715 exit for Aberdeen Proving Ground
  • Proceed to APG Visitor's Center on the right. Use far right-hand lane to access Visitor's Gate